Welcome to Ruihui official website Chinese |English

How to adjust the height of the feeding line of the punch feeder

Time:2022-07-29 16:01:10  Source:www.ruihui.net  Author:RUIHUI
We all know that after the customer orders the punch feeder, we need to design the feeding height of the punch feeder according to the customer's needs. In installation and use, the level adjustment setting of the feeder and the die is the basic requirement for the installation of the punch feeder. So what is the feed height?
 
The feed line height of the punch feeder is a value that corresponds to the height of the die line used by the punch press. Generally, after the punch press replaces the die, the height of the die line will change, so it is necessary to adjust the feed line height of the punch feeder.
 
However, many customers still have questions about the height of the feeding line of the punch feeder, which are generally the following problems.
 
    1. Is it possible not to adjust the height of the feeding line of the punch feeder?
 
The height of the die line corresponding to different dies is different. If the height of the feed line of the punch feeder is not adjusted after the die is replaced by the punch press, it will lead to inaccurate feeding during the punching operation, resulting in scratches and defective products in the punched product. This phenomenon, in severe cases, may cause damage to the mold and the punch feeder.
 
    2. How to adjust the feeding height of the punch feeder?
 
   First, install the punch die before adjustment.
 
    Then determine the position of the horizontal line of the new mold, and adjust the height of the feeding line of the punch feeder according to the height of the mold, so that the height of the feeding line of the punch feeder is consistent with the horizontal line of the stamping die, so as to ensure more accurate and smoother conveying in the production process.
 
    In addition, many operators at the customer site like to introduce the material into the mold guide column by feeding after the mold is installed, and then adjust the feeding height of the punch feeder according to the material, which is an incorrect adjustment method. , which will cause the feed line height of the punch feeder to be higher than the die line height of the mold, resulting in problems such as inaccurate feeding.
 

Address: Chuangxing NO.12, Baisha , Humen , Dongguan, Guangdong, China

Tel:+86-769-8929 6726  Mail:sales@ruihui.cn

WhatsApp/WeChat:+86-13826917409